Cutback bitumen manufacturer in various grade rapid curing

Home » Cutback bitumen manufacturer in various grades of MC SC RC » Cutback bitumen manufacturer in various grade rapid curing
atdm

Rapid curing cutback bitumen

Rapid Curing Cutback Bitumen is made by reducing the viscosity of and ordinary bitumen by adding mostly petroleum type solvent. Cutback Bitumen are used because their viscosity is lower than that of neat asphalt and can thus be used in low temperature applications.

RC cutback bitumen

After a RC cutback is applied the solvent evaporates away and only the Bitumen is left. A rapid curing cutback bitumen is said to cure as the petroleum solvent evaporates.

Cutback bitumen rapid curing

Rapid curing Cutback bitumen are typically used as prime coats and tack coats. Generally Cutback Bitumen are divided into three groups depending on their volatility of the solvent added:

Liquid rapid curing bitumen

The rapid curing cutback bitumen products are prepared with a light, rapidly evaporating diluent such as a naphtha or gasoline. Rapid curing cutback asphalt cement is a combination of light diluents of high volatility, generally in the gasoline or naphtha boiling point range (RC-70, 250, 800, 3000), and asphalt cement.

RC 70 RC 250 RC 800

Rapid curing cutback asphalt combinations are prepared to start from the lighter diluents, and even from the fluid of higher viscosity. The grades used for rapid curing cutback bitumen are RC-70, RC-250, RC-800, and RC-3000. Here, the value given by numbers 70, 250, 800, and 3,000 represents the kinematic viscosity of the bitumen given in centistokes. The solvent concentration of rapid curing asphalt is 15-45% of the volume of asphalt cement used. Mainly two tests are conducted on cut-back asphalt and are given as 1) residue and 2) cutback test. The testing of residue focuses on examination of penetration, ductility, and solubility. The testing of cutback bitumen includes the distillation, viscosity, and flash point tests. The degree of liquidity developed in each case depends principally on the proportion of solvent to asphalt cement. To a minor degree, the liquidity of the cutback may be affected by the hardness of the base asphalt from which the cutback is made. The degree of fluidity results in several grades of cutback asphalt—some quite fluid at ordinary temperatures and others somewhat more viscous. The more viscous grades may require a small amount of heating to make them fluid enough for construction operations. Asphalt cutbacks use petroleum solvents for fluidifying asphalt cement. The solvents are called distillate, diluents, or cutter stock. If the solvent used in making the cutback asphalt is highly volatile, it will evaporate quickly, while solvents of lower volatility evaporate more slowly. Based on the relative speed of the solvent fraction’s evaporation, cutback asphalts are divided into three types: rapid curing (RC), medium curing (MC), and slow curing (SC).

Application

The rapid-setting grades are designed to react quickly primarily for spray applications, such as bond/tack coats, aggregate chips seals, sand seals, and similar surface treatments. Rapid curing Cutback bitumen is typically used as prime coats and tack coats. Generally, Cutback Bitumen are divided into three groups depending on the volatility of the solvent added: RC cutback bitumen After an RC cutback is applied the solvent evaporates away and only the Bitumen is left. A rapid curing cutback bitumen is said to cure as the petroleum solvent evaporates. Rapid Curing Cutback Bitumen is made by reducing the viscosity of ordinary bitumen by adding mostly petroleum-type solvent. Cutback Bitumen are used because their viscosity is lower than that of neat asphalt and can thus be used in low-temperature applications.

Our approvals

Open chat
Hello
Can we help you?